EN
Make sure the child restraint system is properly installed with your child, prior to the trip.
Do not attempt to make any adjustments during driving.
"Only suitable if the approved vehicles are fitted with a 3-point with retractor safety-belts, approved to
UN/ECE Regulation No. 16 or other equivalent standards:'
The rigid items and plastic parts of a child restraint must be so located and installed that
they are not liable,during ever day use of the vehicle, to become trapped by a movable seat or in a
door of the vehicle;
Airbags can cause injury. Do not use this child seat on a passenger seat fitted with a frontal airbag.
Any straps holding the restraint to the vehicle should be tight,that any straps restraining the child
should be adjusted to the child's body,and that straps should not be twisted;
It is very important of ensuring that any lap strap is worn low down, so that the pelvis is firmly
engaged, shall be stressed;
The child restraint system should be changed when it has been subject to violent stresses in an
accident;
Do not make any alterations or additions to the device without the approval of the competent
authority, and a danger of not following closely the installation instructions provided by the child
restraint producer.
Since the child restraint system may not be provided with a textile cover, it shall be recommended that
the chair should be kept away from sunlight, otherwise it may be too hot for the child's skin;
Never leave your child unattended in the child restraint system.
Any luggage or other objects liable to cause injuries in the event of a collision shall be properly
secured.
The child restraint must not be used without the cover.
The seat cover should not be replaced with any other than the one recommended by the
manufacturer, because the cover constitutes an integral part of the restraint performance.
Your car seat must be positioned and installed properly so that, under normal vehicle usage
conditions, no part can become jammed under or between any moveable
seat or in the vehicle door.
If there is an interference between the adult safety-belt buckle and child restraint system, it is
unsatisfactory position of the adult safety-belt buckle relative to the main load bearing contact points
on the restraint. You shall be advised to contact the
child restraint manufacturer if in doubt about this point.
Do not use any load bearing contact points other than those described in the instructions and marked
in the child restraint.
When you use this child restraint system at Gr. I, and fix the seat by ISOFIX must read the car
manufacturer's handbook.
Warning: Airbags can cause injury. Do not use this child seat on a passenger seat fitted with a frontal
airbag.
Photo C.
4. Adjustments
4.1 Remove the seat cushion
The Ambra must be used for children from 0 to 1Okg (approximately new born to
10 months old) with the seat cushion (Fig. 1).
Once your child 's weight is between 1Okg to 13kg (the approximately 10 months to approximately
15months) you must remove it as below:
Press on the release button (part no.23 page 01) and separate the buckle tongue
(part no.24),
Then pull at the edge of the seat cushion to remove it (fig.2)
4.2 Adjusting the handle position
The handle (part no.27) of Ambra child seat can adjust to difference position. Method as below:(Fig. 3)
4.2.1 Press the handle release button (part no.26 page 01) on the handle at same time by both hand.
4.2.2 Now toward the arrow direction push backward and forward can adjust the
position. (Fig. 3)
4.2.3 Then Release the button when the handle is at the right position. The function of the position as
(fig. 4,5,6) shows.
To Next Page
Loading...
