12
A. Frame opening (fig.1-2-3)
Assembly steps
1. Open the frame in the direction depicted by the arrow in the images until you
hear the „click” sound. Then check that the frame has locked in place.
B. Wheels installation and function
1. Insert the front wheels in the spot designated for them. Make sure that the
wheels were locked in and do not fall off. (fig. 4).
2. Push down the button on the wheel when you want only forward facing front
wheels, thus cancelling the pivot function. Lift this button and the front wheels
can pivot 360 degrees (fig.5).
G. Canopy use (fig. 23)
C. Seat operation
1. Open the seat by pulling the backrest up and back until you hear the click
sound (fig. 9). Make sure that the seat has locked into place (fig.10).
D. Bumper bar installation and use
E. Handlebar operation (fig.19-20)
1. Pull the backrest adjusting button in order to adjust the angle of the backrest.
1. Close and open the canopy according the arrow in the image. Open the
zipper to extend the canopy. Lift fabrics on the rear side of the canopy in order
to gain ventilation during hot temperature.
1. Simultaneously press down the lock button on both sides to adjust the
position to up or down (fig. 24).
4. Insert the rear wheels in the spot designated for them. Make sure that the
wheels were locked in and do not fall off. (fig. 7).
1. The handlebar of baby stroller Aspen is telescopic, which means it’s length
can be increased or decreased based on the parent’s height. Push the
adjustment knob and push down or lift in order to obtain the desired height
3. If you wish to remove the bumper on just one side for easy access, press the
lock button on the side and remove the pivoting bumper (fig.18).
5. Remove the rear wheels by holding down the locking iron plate and pulling
out the wheels (fig.8).
F. Backrest adjustment (fig. 21-22)
2. Lift the bumper bar and make sure it has locked into place (fig. 11).
3. When you want to remove the front wheels, simply press the small iron plate
and pull put the front wheels (fig.6).
1. Insert the ends of the bumper bar into the designated spot on the seat
(fig.16).
H. Footrest adjustment
3. To install the seat on the frame, insert it in the dedicated spot on the frame
(fig.12) according to the arrow in the images. Make sure it has locked in place
(fig. 13).
2. Press the bumper bar lock buttons at the same time to remove the bumper
from the seat (fig.17).
5. In order to remove the seat from the frame, press down the seat lock button
and lift up the seat from the frame (fig. 15).
4. To install the seat in reverse position, push down both the buttons on the side,
lift the seat from the frame, turn the seat into rear-facing position then clamp
back onto the frame (fig.14).
EN
To Next Page
Loading...