13
3. At the folding articulation, there is a handle. Pull it out in order to complete
folding (fig. 31).
3. To assemble the carrycot liner, put the liner in the canopy and using the
zipper line (fig. 36).
3. Always push down the brake during parking and whenever you are putting in
or removing the child.
1. Open the seat by pulling it upwards, then proceed to lifting the handle. After
that, make sure that the stroller has opened onto all four wheels. Check for the
frame and all it’s articulations to be locked in place (fig.33).
2. Lift the pedal to push the stroller normally.
3. To adjust the length, pull the adjusting button up and down to adjust the
length according to your child’s height.
K. Folding
4. The seat folds in the same manner regardless of the seat position, forward or
rearward facing (fig.32).
2. To operate the canopy, push both buttons on the sides of the carrycot and
push down or lift up the canopy (fig.35).
1. With the carrycot facing up, pull the metal bar upwards then snap the iron
wire into the buckle (fig. 34).
2. After adjusting the height of the handlebar to the lowest position, press the
buttons on the handlebar and leave it to slide down (fig. 29-30).
L. Stroller opening after fold
N. Car seat connection
I. Five-point seat belt use
J. Brake operation
1. When the brake pedal is pressed down, the rear wheels will not move (fig.
26).
1. Fold the backrest over to the front side by pushing the button and backrest
forward (fig. 27-28).
3. Be aware of the safety warnings for the infant car seat, respect them and do
not overload!
4. This type of adapters will match our own brand (Coccolle) car seat, as well as
certain models from Maxi Cosi and Cybex. Contact your retailer for detailed
information.
1. Bring all 4 belts to the centre and buckle them in the central buckle (fig. 25).
2. The same steps are to be done regardless of the seat position, forward or
rearward facing.
2. To open, press the buckle and the belts will pop out.
M. Carrycot operation
1. You will find included in this package a set of adapters that will connect your
infant carrier to the stroller frame. Insert the adapter in the car seat that insert
it the mounted piece into the stroller frame. Be aware to use the correct side,
adapters are marked left and right.
2. To remove the adapters, simply press the button above the mount, around the
lateral side of the canopy and remove the adapter from the carrier.
4. To use the parasol, simply pull it out from under the canopy (fig.37).
EN
13
To Next Page
Loading...