8
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
Tips & Troubleshooting
Problem Solution
I am getting a lot of feedback
through the speaker when
using the microphone
Try moving away from the speaker system when using a
microphone with the system.
I can’t hear anything from
my microphone through the
speaker
- Ensure that you have both the MIC VOL and VOLUME
knobs adjusted to increase microphone volume.
- Check that the mic is turned on.
I can’t hear my guitar through
the speaker
- Ensure that you have both the GT VOL and
VOLUME knobs adjusted to increase guitar volume.
- Check any volume controls on your guitar
There is humming or buzzing
through the PA & DJ Speaker
System
Try to keep any audio signal cables away from the DJ
Speaker power cords. This can sometimes result in a
humming or buzzing from the speaker system.
My PA & DJ Speaker System
won’t turn on
- Ensure that you have correctly connected the Power
cable to the rear of the unit. It should not be loose.
- When charging the system, the power switch on
the rear of the unit needs to be ON. Leave to
charge for at least 8hrs.
- Make sure the power is on at the outlet.
My wireless microphone won’t
turn on
- The included wireless microphone requires 2 x
AA batteries to operate (included). Unscrew the battery
case o the bottom of the unit and change the batteries if
required.
- Make sure the switch on the handle of the
microphone is set to ON. The red light should ash
briey to indicate you have turned it on.
I am not picking up any radio
stations
- The PA & DJ Speaker System will only receive FM
radio stations not AM.
- You can extend the telescopic antennas at the rear
of the unit to increase the reception.
The speaker makes a noise
when I rst turn it on
This is normal when the system rst initialises.
The fuse has blown in the
system
The PA & DJ Speaker System uses a replaceable 12A, 250W
glass fuse. Refer to page 9.
10
To Next Page
Loading...
