7
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
4. SETTING VOLUME LEVEL
1. When the Digital Notetaker is in standby mode, press the + button to
increase volume or the – button to decrease volume.
2. There are 10 volume levels, 0 is the lowest with 9 the maximum.
5. LOCKING THE DIGITAL NOTETAKER
1. Slide the Hold switch up to the lock the Digital Notetaker.
2. When locked, the Digital Notetaker cannot play or record any audio.
3. When a button is pressed Hd will be shown on the LCD display.
Note: If your unit is not working, check that the Hold switch is in the off
position.
6. RECORDING AUDIO
1. Power on the unit by holding down the Play button for 2 seconds.
2. Select the Sound Quality by using the HP/LP button.
(See step 3 for more details)
3. Select the File Folder by pressing the File/Erase button
(See step 9 for more details)
4. Press the REC button once. The record icon will be shown on the
LCD display.
5. The new file number will be shown on the display
(See step 9 for more details)
6. Press the STOP button once to end the recording.
Warning: Do not remove the batteries while recording or otherwise interrupt
the recording process. Doing so may result in lost or damaged recording files.
7. USING A MICROPHONE
1. The Digital Notetaker comes with a 3.5mm input for recording using a
microphone (not supplied)
2. Simply insert the microphone jack into the microphone port marked
on the top of the unit.
Instructions
To Next Page
Loading...