9
PROGRAMMABLE FEATURES:
Feature LtsFlash1X Lts Flash 2X Lts Flash 3X Lts Flash 4X Default
1. Run Time 5 Min. 10 Min. 15 Min. 20 Min. 10 Min.
2. Ign. 2 Off during Crank On during Crank On
3. Parking Lights ON Flash ON
4. Tach Mode Tachless Tach Tach
5. Voltage Level > 0.5V B4 Start < 0.5V B4 Start > 0.5V
6. Diagnostics Off On Off
7. Crank Time 0.8Sec 1.0 Sec 1.5 Sec 2.0 Sec 1.0
8. Gas/Diesel Gas Diesel 10 Diesel 15 Diesel 20 Gas
9. BTN Press 1 Press Start 2 Press Start 2 Press Start
10. Unlock Out Single Pulse Double Pulse Single Pulse
To Program Features:
1. Turn the ignition key to the ON position.
2. Press and release the program button 3 times, the parking lights will turn ON.
3. Immediately turn the ignition key OFF, then back to ON. The parking lights will turn OFF.
4. Press and release the program button 2 times, the parking lights will flash once indicating you are in
programmable feature #1.
5. Press the vehicle's brake to change the selection of programmable feature #1 OR use the program button to
advance to the next feature. Each button press advances one feature, the parking lights will flash indicating
the feature number.
6. Programming will exit after 15 seconds of inactivity or if the ignition is turned OFF, the parking lights will give
one long flash to confirm exit.
NOTE: New feature #10, Door Unlock Output while remote start is active. This output is also the factory disarm
output. To unlock, press and hold the transmitter button for 3 seconds while the vehicle is remote started.
NOTE: Once you enter the programming mode, do not allow more that 15 seconds to pass between steps, or
the programming will be terminated.
To Next Page
Loading...
