Code Blue IA3100 - IA3100 Programming Command Reference

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-145-Epage 13 of 23
IA3100
Administrator Guide
Programming Command List
Command Explanation Format/Default
10 1
st
Voice message (See also command 30-34) 10<<voice message>>#
11 2
nd
Voice message (See also command 30-34) 11<<voice message>>#
30 1
st
single instruction must be less than 18
seconds and will be played only to the guard
30
31 1
st
message must be less than 18 seconds and
will be played at the IA3100 until guard answers.
(see command 72)
31 / Default
32 1
st
instruction must be less than 9 seconds and will
be played at the IA3100 until the guard answers.
2
nd
message must be less than 9 seconds and will
be played to the guard and at the IA3100 after the
guard answers. (see command 72)
4
33 1
st
message must be less than 9 seconds and will
play at both ends after the guard answers.
2
nd
message must be less than 9 seconds and
will play at both ends after the 1
st
message. (see
command 72)
32
34 Recording playback level – This is the volume
level that a recording will be played at.
34<<level>># / Default = 2
1=low
2=medium
3=high
35 Ring down selection & Automatic Number
Identication: Command 0,1, 2 and 3 are for
standard analog trunck line mode; Commands
4,5 and 6 are used for analog Ring Down
lines. (ANI) The ANI is 27 DTMF tones sent at
the beginning of the call. The ANI is translated
by software at the guard station to give the units
location, data input information, condition of
inputs, and status of the phone’s batteries.
35<<ANI Selection>># / Default
= 0
Regular line
0=Disable ANI
1=”Help” only
2=”Info” only
3=”Help”+”Info”
36 Call Button Function – This command is used
with the IA3100-K Keypad faceplate to allow for
a number to be automatically dialed before using
the keypad. (This feature only relates to the black
“Call” button)
36<<Function>># / Default = 0
0 = Auto Dial Off
1 = Auto Dial On
37 Call Progress Tone Detection – This command
allows for the enabling and the disabling of the call
progress tone monitor for hang up.
37<<mode>># / Default = 1
0 = Disabled
1 = Enabled
38 Disconnect Pulse Width (Wink) – This is the
minimum amount of time that the phone line must
drop or reverse polarity for the IA3100 to hang up.
(0-9)
38<<time>># / Default = 2
0 = Disable
1 - 9 = 100 Milliseconds - 900
Milliseconds
(Continued on next page)