Code Corporation CR1400 - Maintenance and Support for CR1400; CR1400 Cleaning Procedures; Technical Support and Returns Process

C006819_05_CR1400_User_Manual
8
15.0 - Reader Pinouts
The connector on the CR1400 is an RJ-50 (10P-10C). The pinouts are as follows:
Pin 1 +VIN (5v)
Pin 2 USB_DM
Pin 3 USB_DP
Pin 4 RS232 TX (output from reader)
Pin 5 RS232 RTS (output from reader)
Pin 6 RS232 RX (input to reader)
Pin 7 RS232 CTS (input to reader)
Pin 8 External Trigger (acve low input to reader)
Pin 9 N/C
Pin 10 Ground
The CR1400 needs only a minimum of maintenance to operate. A few ps are given below for maintenance suggesons.
Cleaning the CR1400
The CR1400 window should be clean to allow the best performance of the device. The window is the clear plasc piece inside
the head of the reader. Do not touch the window. Your CR1400 uses CMOS technology that is much like a digital camera. A dirty
window may stop the CR1400 from reading bar codes.
If the window becomes dirty, clean it with a so, non-abrasive cloth or a facial ssue (no loons or addives) that has been
moistened with water. A mild detergent may be used to clean the window, but the window should be wiped with a water moistened
cloth or ssue aer using the detergent.
The following agents are approved to clean a Code bar code reader:
• Alcohol Wipes
• Clorox® Disinfecng Wipes
• Clorox Bleach Soluon (10% clorox bleach, 90% tap water)
• Medical DiAirKem
• Sani-Cloth® HB, Super Sani-Cloth® Germicidal, Sani-Cloth® Plus Germicidal Disposable Wipes
• Virex® II Disinfectant Cleaner
Technical Support and Returns
For returns or technical support call Code Technical Support at (801) 495-2200. For all returns Code will issue an RMA number which
must be placed on the packing slip when the reader is returned.
Visit hp://www.codecorp.com/codesupport.php for more informaon.
16.0 - CR1400 Maintentance