Code Reader 1000 Configuration Guide

7
C005435_12_CR1000_CR1400_CR8000_CongurationGuide
Continuous Scan
Both Imagers
Continuous Scan Off - Default
Aztec Off
Aztec On - Default
Codabar On - Default
Codabar Off
Aztec Inverse & Normal
Aztec Inverse On
Motion Detection On,
Start Delay 0,
Dark Environment
Motion Detection On,
Start Delay 500ms,
Dark Environment
Motion Detection On,
Start Delay 500ms
Motion Detection On,
Start Delay 0
Enable Motion Detection
with Stand Detection, Start
Delay 0 - Default
NOTE: The conguration change will take effect immediately and saved to memory.
Motion Detection
Scanning Off
CR1000/CR1400/CR8000 Conguration Guide
Disable Motion Detection with
Stand Detection
Moon Detecon
• CR1000 and CR1400 readers that feature stand detecon will default to
moon detecon reading when the reader is placed in a stand. Scanning
‘Disable Moon Detecon with Stand Detecon’ (B2), will put the reader
into moon detecon reading when the reader is both in and out of the
stand
• To disable all moon detecon, you must scan ‘Disable Moon Detecon
with Stand Detecon’ (B2) and ‘Moon Detecon Scanning O’ (D1)
• To enable moon detecon with stand detecon aer all moon detecon
has been turned o, scan any ‘Moon Detecon On’ (C1-C4) code, and
scan ‘Enable Moon Detecon with Stand Detecon’ (B1)
• To enable moon detecon in readers that do not feature stand detecon,
scan the ‘Moon Detecon On’ seng you prefer (C1-C4)
Refer to the reader’s QuickStart Guide or User Manual to determine if your
reader features stand detecon.
Australian Post On Australian Post Off - Default
Codablock F On Codablock F Off - Default Intentionally Left
Blank

Code Reader 1000 Specifications

General

Brand	Code
Model	Reader 1000
Category	Barcode Reader
Language	English