6.
7. INSTALLATION AND START-UP – SERVICE Cater
7.1.
Place the machine on a flat surface that is impermeable to water.
7.3. Electrical connection
NB Connect the plug to a separate earthed wall socket (230 V
10 amp).
7.2. Connect to your cold water feed using the connection
tube supplied.
It is recommended that you connect the tube to a shut-off tap.
For the best results, pressure should be between 14.5
and 72.5 psi (1 - 5 bar).
It is the responsibility of the end customer/user to ensure that the
water feed is compliant with the manufacturer’s instructions.
In hard water areas, it is recommended that a lime filter is fitted
to the water feed before the machine is installed.
To Next Page
Loading...
