Coffee Queen TOWER - Programming and Adjustments - Time;Sensor; Adjusting Brewing Time; Calibrating Temperature Sensor

32.
11. Programming. Adjustings. - SERVICE TOWER
ADJUST BREWING TIME. (Coffee Ready).
Adjust Signal
Off 6
-25% -5
-20% -4
-15% -3
-10% -2
-5% -1
0% 0
5% 1
10% 2
15% 3
20% 4
25% 5
1. Push buttons 2, 3 at the same time for 5 seconds until you hear 5 beeps .
Left side. Display shows: present setting. Adjust with the buttons 1 and 2.
Confirm the new settings by pushing button 3 once.
Push buttons 5, 6 at the same time for 5 seconds until you hear 5 beeps.
Right side. Display shows: present setting. Adjust with the buttons 4 and 5.
Confirm the new settings by pushing button 6 once.
CALIBRATE TEMPERATURE SENSOR.
1. Push buttons 1, 2, 3 at the same time for 5 seconds until you hear a beep twice.
Left side. Display shows: present setting. Adjust with the buttons 1 and 2.
Confirm the new settings by pushing button 3 once.
NOTE! When calibrating the temperature sensor, you must check the present
temperature in water tank.
Adjust Signal
98° 2
97° 1
96° 0
95° 1
94° 2
93° 3
92° 4
91° 5
Off 6
1 4
2 5
3 6
0
ON
1 4
2 5
3 6
-1
ON