Need help?Do you have a question about the Cognex In-Sight 1700 Series and is the answer not in the manual?
General| Model | In-Sight 1700 Series |
|---|---|
| Camera Type | Area Scan |
| Frame Rate | Up to 60 fps |
| Connectivity | Ethernet |
| Software | In-Sight Explorer |
| Lens Mount | C-Mount |
| Protection | IP67 |
| Sensor Type | CMOS |
| Resolution | 640 x 480 pixels |
| Illumination | Integrated LEDs (configurable) |
| Operating Temperature | 0°C to 45°C |
| Communication Interface | Ethernet |
Overview of In-Sight series vision sensors for reading identification marks on silicon wafers.
Details how the In-Sight wafer reader operates on an Ethernet TCP/IP network.
Describes connecting the wafer reader to its standard components and breakout module.
Explains browser configuration for communication with the wafer reader.
Outlines prerequisites and steps for installing the In-Sight PC Host program.
Details procedures for adding the wafer reader to a network, considering DHCP.
Guides users on establishing a connection to the wafer reader via an Internet browser.
Lists SEMI specifications for wafer identification the reader supports.
Explains acquiring a suitable image of the wafer mark before setting configuration.
Details settings within each Config (0-9) to customize mark reading.
Explains how Options tab selections control the application's runtime operation.
Describes job files stored in flash RAM and accessed via the File tab.
Explains how to save changes made to job configurations.
Guides configuring the wafer reader to load a specific job at startup.
Describes the Run tab as the sole view of the wafer reader during runtime.
Explains switching the wafer reader between Online and Offline modes.
Details the record of recent read results and statistical records for each Config.
Details network configuration, including DHCP, IP address, and subnet mask.
Explains how to configure the wafer reader's RS-232 serial port.
Lists basic commands for remotely controlling the wafer reader via Ethernet or serial port.
Describes EV commands for controlling the wafer reader remotely.
Details EV commands to retrieve settings and read results.
Explains EV commands to change Config settings.
Provides general specifications for In-Sight 1721/1722, 1701, and 1700 wafer readers.
Details the wafer reader's acquisition trigger input and LED outputs.
Presents dimensional drawings and mounting information for wafer readers.
Advises on precautions to reduce risk of injury or equipment damage during installation.
Step-by-step guide to update the wafer reader's firmware and install necessary files.
Details copying required firmware and configuration files to the wafer reader's flash memory.
Details the horizontal mirror attachment for low mounting profiles on 1721/1722.
Explains how to adjust the focus for optimal image acquisition on the 1721/1722.
Describes the horizontal mirror attachment for low mounting profiles on the 1701.
Explains how to adjust the focus for optimal image acquisition on the 1701.
Explains how to convert the mounting configuration of the 1700 wafer reader.
Provides instructions on maintaining the wafer reader's read window for optimal performance.
To Next Page