Coitech HT7715 - Quick start timer; Care and maintenance; Troubleshooting guide; Disposal

7
ENGLISH
Quick start timer
When pressing [ Quick Start Timer ] (9) thedisplay will show thefollowing:
The display will start and an8 minute charge countdown. The battery level icon will
change during charging and thearrows pointing to theplus and minus icons will flash.
The display will stop flashing when thecountdown reaches 0. The “pump engine”
will flash for 2 minutes. The engine will then be ready to start.
Note: After the“pump engine” has flashed for two minutes thecharger will return to
charge mode. To stop charging, press [ Charge ] (6).
If theprocess must be repeated for theengine to start, thecharger must be allowed
to rest for 5 minutes before restarting theprocess.
Care and maintenance
• Use asoft damp cloth to wipe theproduct.
• Never use abrasive cleaning agents.
• Before carrying out any maintenance disconnect thedevice from themains.
Troubleshooting guide
If thecharger doesn’t start:
• Make sure that thecharger is connected to a220–240 V AC electrical socket.
• If battery voltage is under 4 V thebattery cannot be charged using this
specific charger.
Disposal
Follow local ordinances when disposing of this product. If you are unsure of how to
dispose of this product, please contact your municipality.
Specifications
Dimensions 270×200×135 mm
Battery capacity 50–350 Ah
Operating voltage 220–240 V AC, 50 Hz
Charging voltage 12 V DC
Charging current Max. 15 A