Cold Jet PR750H - Page 34

PR750H
MECHANICAL MAINTENANCE
Version:
1
Page:
4 of 69
Date:
2020.12.11
1. Procedure for changing CO
2
filter and gasket on PR750H and PR350H
This section will describe how to changing CO
2
filter and gasket on PR750H and PR350H. During this operation it’s
important to activate the emergency stop button!
Disassembling the CO2 filter housing
Remove the filter housing by loosening the 4 screws [1] and pull the filter housing end plate
[2], gasket [3], filter [4] out wards. Replace the gasket [3] and the filter [4].
Notice!
It is very important to be careful and not get any dust or dirt into the filter housing under this
Operation, this could block the Danfoss solenoid valves .
1
2
3
4