Coleman 9948 Series - Cooking Operations & Post-Use; Lighting, Cooking, and Shutdown; Disassembly, Cleaning, and Storage

7
To Turn Off
Tear Down/Clean cont.
■ Be sure stove is cool.
■ Always detach propane cylinder
outdoors away from ignition sources.
■ Unscrew the threaded outer
sleeve that connects the regulator
to the stove by turning it counter-
clockwise then remove regulator
from the stove fuel line.
■ Place stove on side on
a ground cloth to protect
the stove finish.
■ Remove legs by
unscrewing from receivers
on bottom of stove.
To Remove Legs from Stove
■ Push the burner valve
knob inward and close
burner valve firmly.
Tear Down/Clean
■ Close Lid. Make sure Latch
engages.
■ Clean griddle with warm
water and mild household
cleaner. Do not use abrasives.
■ Wipe the stove clean with
soft cloth and mild household
cleaner. Do not use abrasives.
■ The 1/2 griddle can be
placed in dishwasher for easy
cleaning.
■ Thread foot pad into leg.
Storage
■ Disconnect regulator from cylinder. If stored indoors, detach and leave cylin-
der outdoors.
■ Store propane tank in safe manner. Refer to Chapter 5 of
Standard for
Storage and Handling of Liquefied Gases
, ANSI/NFPA 58. Follow all local
codes. Always store propane tanks outdoors.
■ Store stove in a dry, clean and safe place.
■ Place the cleaned cooking grid, griddle and REGULATOR into the stove for
storage.
■ For long-time storage, clean and dry all stove parts before storing. This will
keep the unit clean and ready for the next season.
■ Place the stove in a plastic bag and tie it shut.
Before Cooking
CAUTION
• Do not place a pot or a pan on griddle surface. Damage will occur and
void the warranty.
■ Clean cooking surface and cooktop with warm water and detergent
before first use.
To Light
■ The unit may be match lighted
if there is no ignition.
■ First, remove grill surface.
■ Hold lighted match next to
BURNER and open BURNER
VALVE slowly.
■ Adjust flame to desired heat
level.
■ Flame should be blue with a
hint of yellow on tips.
■ Open BURNER VALVE and
push igniter button several times
until burner lights. (If the stove is
wet, the igniter may not spark
until it dries out.)
■ Open the stove lid. Do not
attempt to light the stove with lid
closed.
■ Detach propane cylinder from
regulator and replace the plastic
protective cap onto cylinder threads.