Coleman CHD200 - Video Length Settings; Audio Recording Settings; Shot Lag Settings; Motion Sensor Sensitivity

3. Using Your CamĞƌĂ

submenu.
2. Press the LEFT or RIGHT buttons to navigate the menu and press the
OK button to confirm your selected setting (1920x1080P, 1280x720P,
720x480P, 640x480P).
3.1.5 Video Length
This function lets you set the length of each video recorded. The longer the
video, the larger the file size of the video.
1. In the Settings Menu use the LEFT or RIGHT buttons to select ‘Video
Length’ and press the OK button to enter the ‘Video Length’ submenu.
2. Press the LEFT or RIGHT buttons to navigate the menu and press the
OK button to confirm your selected setting (3-60 Seconds, 1 Minute, 2
Minutes, 3 Minutes, 4 Minutes, 5 Minutes, 6 Minutes, 7 Minutes, 8
Minutes, 9 Minutes, 10 Minutes).
3.1.6 Audio Recording
This function allows the camera to record audio while recording video.
1. In the Settings Menu use the LEFT or RIGHT buttons to select ‘Audio
Recording’ and press the OK button to enter the ‘Audio Recording’
submenu.
2. Press the LEFT or RIGHT buttons to navigate the menu and press the
OK button to confirm your selected setting (On, Off).
3.1.7 Shot Lag
This function sets the amount of time in between pictures. This prevents
the memory card from filling up with too many pictures and videos of the
same event.
1. In the Settings Menu use the LEFT or RIGHT buttons to select ‘Shot
Lag’ and press the OK button to enter the ‘Shot Lag’ submenu.
2. Press the LEFT or RIGHT buttons to navigate the menu and press the
OK button to confirm your selected setting (5-60 Seconds, 1-60
Minutes).
3.1.8 Sensitivity Motion Sensors
The sensitivity of the main motion sensor is set here. The sensitivity level
should be based the activity in the area where the camera will be placed.
For interior areas and environments with low activity select ‘High’. For
outside areas and environments with normal activity select ‘Middle’. For
environments with a lot of activity select ‘Low’.
1. In the Settings Menu use the LEFT or RIGHT buttons to select
‘Sensitivity Motion Sensors’ and press the OK button to enter the
‘Sensitivity Motion Sensors’ submenu.