Coleman LAKESIDE 9163-150

To Next Page

Connect Frame to Tent

–Start with the center Grey main pole.

Insert the pin into the end of the grey

main tent pole at tent’s edge. (illus. 3 & 4)

–Go to opposite end of pole and

gradually apply pressure to the pole

forming an arch until you are able to

insert the pin into the opposite pole end.

–Repeat for two black main poles.

Lakeside

™

15’x10’

Layout & Positioning

of Tent, Pole Assembly

–Layout and position tent with door

facing desired direction. (illus. 1)

–Unzip doors.

–Stake down tent corners only, using the

stake loops. Keep the floor taut.

(Intermediate loops will be staked later.)

–Assemble frame poles by interlocking

shock-corded poles. (three poles)

–Insert the grey pole straight through the

center pole sleeves in the middle of tent.

Then insert black poles straight through

outside pole sleeves. (illus. 1)

When You Are Ready To Set

Up Your Tent

–Select a level campsite clear of

rocks, branches and other hard or

sharp objects.

–Do not set up your tent under trees.

–For best results in windy conditions,

position the end of tent into the wind.

–See owners manual for more tips.

Assembled

Black main

poles

inserted

through

pole sleeves

Grey main pole

through center

sleeves

Instructions apply to Part Number 9163-150

illus. 1

illus. 2

Tent stake

through

stake loop

illus. 4

Tent frame set-up

Main Poles

Part No. 9163-503

Main Pole

Part No. 9163-505

Rainfly Poles

Part No. 9163-504

illus.3

Insert pin

into pole end

Rainfly

Part No. 9163-502

Main Tent Poles (Black)

Main Tent Poles (Grey)

Grey Pole

Black Pole

Need help?

Do you have a question about the Coleman LAKESIDE 9163-150 and is the answer not in the manual?

Summary

Tent Setup and Assembly

Layout and Positioning

Position the tent on a level surface, unzip doors, and stake down corners.

Frame Connection

Assemble poles and connect the grey pole through the center, then black poles through outer sleeves.

Attaching Tent Components

Frame Clips and Stakes

Attach frame clips to poles, adjust stakes, and stake remaining loops and door mat.

Rainfly Attachment

Assemble rainfly poles, insert into sleeves, drape over tent, and secure with hooks and tips.

Important Usage and Safety Information

Condensation and Ventilation

Condensation forms due to humidity; minimize by removing wet items and ventilating.

Storage and Care

Dry tent thoroughly before storage; do not pack stakes/poles inside. Do not leave telescoped poles.

Stake Removal

Pull stakes by the stake itself, not the tent fabric or loop, to prevent damage.

Flame and Heat Source Warning

Keep flame and heat sources away from tent fabric; it burns if in continuous contact with flame.