EXAMINE YOUR NEW EON™ FOR ANY SIGNS OF PHYSICAL
DAMAGE. ALSO, ENSURE THAT THE TAMPER-EVIDENT LABELS
ARE INTACT Before shipping, your Eon™ was calibrated and tested by
Colnatec to meet the highest quality standards. It is important that you
take a few minutes to inspect the product to ensure that your equipment
was not damaged or otherwise tampered with during transit.
About Eon™
With the ability to sense deposition and temperature with high precision,
the Eon
™
thin lm controller is one of the newest advancements in Thin
Film deposition controllers. The Eon
™
provides features that help improve
measurement accuracy for better process control.
LabVIEW® Interface
The Eon™ offers a simple LabVIEW® interface that provides an operating
environment that is intuitive, efficient, and impressive. The Eon™ is easy to
set up right out of the box.
Software Updates
The Eon
™
interface software can be upgraded on site to provide software
improvements. There will be notications when these updates become
available.
Inspection and Initial Setup
Examine Eon
™
for any signs of physical damage. Also, make sure that the
tamper-evident labels are intact. In order to ensure safe, correct operation
of your Eon
™
, please follow the step-by-step instructions presented in the
Eon
™
Quick Start guide included with your product.
Warranty
Eon
™
is warranted to the original purchaser to be free of any
manufacturing-related defects for one year from the date of purchase.
Colnatec reserves the right to repair or replace the unit after inspection.
69
Appendix C Safety, Handling, & Support
To Next Page
Loading...