What causes print shifting or junk printing on a Colorjet Vastrajet Printer?
If your Colorjet printer is printing shifted output or junk prints, the encoder scale may have ink stains. If the print shows vertical color bands, clean the encoder scale or replace it if it's faulty. Also, ensure the encoder sensor is clean; clean it or replace it if necessary.
What to do if Colorjet Vastrajet Printer Manager is not showing 'Ready'?
If the Colorjet Printer Manager isn't showing 'Ready,' first, ensure the USB cable is securely connected. If it is, and the issue persists, try replacing the USB cable. If the problem continues, refer to the 'PRINTER NOT INITIALIZING' section or the 'Installing the Printer Manager' section. If an error appears indicating incompatibility between the Main Board and Head Connector Board (HCB), contact the Head Office or CES.
How to troubleshoot a Colorjet Vastrajet Printer that is not initializing?
If your Colorjet printer is not initializing, start by checking the 24V power supply output and replace the power supply if needed. Then, check the red LED on the Servo Driver; if it's off, inspect the power connection and trace any faults. Also, ensure the Carriage Safety switch isn't activated by removing any obstacles and releasing the Safety Flaps, if pressed. Check the power 24V and 5V on Main Board and check 24V power on the Head Board connector. Finally, make sure the Emergency Button is not pressed; release it if it is.
To Next Page
General
