Fitting the annex:
• The detachable side of the trailer's
body canvas is zipped out.
• The annex cabin is zipped in.
• The poles with accompanying two
round corners are put into the
sleeve inside the annex.
• The support poles with hook end
are put into the two holes in the
trailer's steel section at the floor.
• The two support poles with clamps
are placed in the corners of the
floor to fix the main tent.
• The PVC floor of the annex is then
stretched and pegged all the way
round, do not tighten too much.
ACCESSORIES TO THE
TRAILER TENT
Sun canopy and tent
UK
• Finally place the fibre glass pole inside
the ventilation flap, where after the
inner tent is fitted.
The door canopy is fitted as follows:
• The door canopy is zipped together
and the poles are fitted with guy
ropes.
Extra sun canopy is fitted as
shown:
• The sun canopy has 3 brass eyelets in
each end. The one fits the awning fra-
mes spigots and is then attached to
the guy rope on each side. The 3 legs
are fitted and pegged with the guy
rope.
11
To Next Page
Loading...
