Combi-Camp Valley - Integrated Sun Canopy;Awning; Canopy Erection

8
• The height is adjusted on the two
legs. Adjust the integrated frames
and lock the adjuster.
• The side can now be pegged or
rolled back to the trailer.
IMPORTANT: make sure the
elastic flap is covering the
zipper.
Erection of integrated,
sun canopy/awning
The frame system is shown in fig. 6
• The body canvas is lowered by use
of two thumb screws, so that all
force is reduced from the tent
canvas and the integrated frames
can move freely. The canvas is
now zipped on to the COMBI-
CAMP.
• The sun canopy is put on top of
the integrated frames, whilst they
are pulled out. Both the frames 25
mm and 22 mm are pulled out,
such as the little pressure spring is
engaged into the 25 mm frame
and this is pulled out 3/4 way.
• Hereafter the front section of the
frame is attached (fig. 6). Now the
frame is adjusted so that the
canvas is nice and tight.
Fig. 6
INTEGRATED SUN
CANOPY/AWNING