Combi Flex - Wheel Assemblies; Attaching Rear Wheels; Attaching Front Swivel Wheels; Removing Front Swivel Wheels

- 4 -
,
push both
brake levers
.

, lift
both brake
levers .








, lift both
swivel lock levers .
, push
both swivel lock levers
.
 Push the guardrail onto the guardrail posts on
the armrest until they lock in place. Check to make sure each side is firmly
attached.
 Press the buttons on each side of the armrest while
pulling the guardrail away from the armrest to remove.





1. Stand behind the stroller.
2. Locate the small open-
ing on each rear wheel
assembly.
3. Locate the small silver pin on each rear stroller leg.

4. Insert the leg into the
wheel assembly until the
small silver pin locks into
the opening.

Place front swivel wheel
assembly on the swivel
shaft. The assembly is
secure when it locks onto
the shaft.

Press in the square button
located at the bottom of the
wheel holder while pulling the
assembly off of the swivel
shaft.
Release Button