5
Install the child cup holdes (G) into the cup holder
mounts (H) on each side of the stroller. Pull up-
ward on the cup holder to make sure it is locked
into place.
Install the child snack cup (I) into the snack cup
mount (J) in the center of the stroller. Pull upward
on the snack cup to make sure it is locked into
place.
Install a canopy pivot (K) into
each canopy mount (L) until it
locks into place. Pull upward
on the canopy to make sure it
is securely installed.
Fasten the hook and loop fastener
located on both sides.
Slide the parent’s cup holder (M) onto the mounting
post (N) until it locks into position.
Section 4 - Cup and Snack Holders
Section 5 - Attaching the Canopy
Section 6 - Attaching the Parent’s Cup Holder
The canopy is not intended to
provide UV protection.
WARNING
To Next Page
