3
Rear - xCam2
Figure 2: Rear Panel
RJ-45 Jack
This RJ-45 connector is used for power connection when the camera
is under wireless mode. A customized PoE (Power over Ethernet)
splitter.
Reset Button
When pressed and released the reset button, the xCam2 will reboot
(restart).
To restore the factory default values:
1. Power On.
2. Keep holding the reset button down for 5 seconds.
3. Release the reset button, the xCam2 is now using the factory
default values.
Microphone
The built-in microphone is located on the front of the device.
Speaker
The built-in speaker is located on the rear of the device.
To Next Page
Loading...
