INSTRUCTIONS FOR THE USER
26
WASH CYCLE SELECTION
3. Press the "S9" button to select the wash cycle according to the
dirtiness of the dishes:
??H9a short cycle: for glasses and cups;
??H9b medium cycle: for normally dirty dishes;
??H9c long cycle: for particularly deep or dirty dishes and for
utensils;
??H9d intensive cycle: it is possible to perform an intensive wash that
will remain activated until the "S3" button is pressed again or a
maximum time of 8 min. is reached; the pause, rinse and drain (if
required) phases will follow.
STARTING THE WASH CYCLE
4. Press and hold the "S3" button (for about 5 sec.) to set the startup
mode of the chosen wash cycle:
??"H9..." indicator light turns on (steady):
automatic startup by closing the hood.
??"H9..." indicator light flashes:
manual startup pressing the "S3" button.
If the choice of startup of the cycle in automatic mode is performed
with the hood lowered, it is necessary to lift and then close the hood to start
the cycle.
It is important to know that:
? ? the activation of a cycle is shown by the sequential lighting of the
indicator lights of the display;
? ? during the wash or drain phases the tank temperature is shown;
? ? during the dwell nothing is shown;
? ? during the rinse phase the boiler temperature is shown.
To Next Page
Loading...
Need help?
General
