35
Inspect coolant hoses, con-
nections and pipes for cracks
and for leakages (visual in-
spection)
Coolant hoses, pipes and
connections are leaking
Inspect the coolant quality
(visual inspection)
Turbidity, airborne particles
Clean or replace the filter
strainer, see "Cleaning the
filter strainer"
Filter strainer damaged or
dirty
Table 7: Maintenance
9.3. Preparing the unit for maintenance
All necessary safety measures have to be taken to prevent accidents when carrying out the mainte-
nance. The following preparations have to be made:
Terminate the cooling operation.
Let the unit and its coolant cool down to the ambient temperature.
Switch off the unit.
Disconnect the unit from mains by pulling the mains plug.
Secure the unit against being switched on again.
Verify that the unit is disconnected.
Carry out earthing and short circuiting.
Keep unauthorized persons away from the working area.
Place the unit on a level surface.
9.4. Disconnecting the coolant hoses
The coolant hoses are connected to the unit by means of couplings. Coolant inlet and coolant outlet
are labeled with respective symbols.
Figure 7: Labeling of coolant inlet and coolant outlet
To Next Page
Loading...
Need help?
General