10
Ⅵ
ⅥⅥ
Ⅵ. Maintenance
Cable Replacement
Never use a rope of a different size or material and only use genuine
replacement parts.
If the winch is subjected to a high duty or excess load, the rope may require frequent
replacement.
1). Disengage the free-spool
2). Spool the entire wire rope, and then remove it from the drum.
3). Place the replacement wire rope through the fairlead opening, pass below the
drum, and insert it into the hole on the drum core.
4). Tighten the screw downwards to secure the wire rope .
(Engaged) (Disengaged)
Brake Adjustment
When the brake wears to the point that the load begins to slip. The brake can be
adjusted as follows:
1). Loosen the bolt on the brake cover and take out c-rings
2). Insert few washers to maintain the brake spacer between to be 2.2 ±0.25 mm
3). Make sure to keep the clutch base plate counter-clockwise by 150 – 180 degree
To Next Page
Loading...
