Comfee CRM17S3ABB - Placement; Start to Use; Energy Saving Tips

2.3 Placement
® Before using the refrigerator,
remove all packaging
materials including bottom
cushions and foam pads
and tapes inside the
refrigerator , tear off the.
protective film on the door
and the refrigerator body.
® The refrigerator should be
placed in a well-ventiated indoor
place; the ground shall be fla,
and sturdy.
The top space of the refrigerator
shall be greater than 30cm and
Keep away from heat and
‘avoid direct sunlight. Do not " the distances from bothsides.
place the refrigerator in and backside shall be more
moist or watery places fo e ofp | than 10cm o facilitate heat
R ‘ prevent rust or reduction of * dissipation.
insulating effect.
2.4 Start to use
The refrigerator shall stay for half an hour before connecting power
when it s firstly started.
- The refrigerator shall run 2 to 3 hours before loading fresh or frozen
_ 7| foods; the refrigerator shall run for more than 4 hours in summer in
—|| advance considering that the ambient temperature is high.
4
2.5 Energy saving tips
The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight
Let hot foods cool to room temperature before placing in the appliance. Overloading
the appliance forces the compressor to run longer. Foods that freeze too slowly may
lose quality, or spoil
® Be sure to wrap foods properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside the appliance.
o Appliance storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the appliance less efficient.
o Organize and label food to reduce door openings and extended searches. Remove as.
many items as needed at one time, and close the door as soon as possible.