Comfee CRV48S3AST User Manual

2.2 Temperature Control
Lightingkey ~Displayarea Temperature-rise key
Standby button Temperature-drop key
(The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor )
» Display Control
when power-on the beverage cooler, the display screen will display in full last for 3 seconds,
and the start-up tone will ring, and then enter into the display of normal operation;
Normal operation display: (1) In case of no failure, set temperature is displayed; 2 In case of
failure, error code is displayed;
This cooler adopts the touch control of the glass door. Touch siightly when pressing the keys. Itis to
be avolded thatthe area of the display panel is scratched by the sharp things and it shall be kept
away from the environment of high magnetic ield and high humidity. Otherwise the cooler is possible
not to be set and operate normally.
v
Standby function
In standby state,press the standby button until the buzzer rings, the beverage cooler will exit
standby state,and the display screen will display the set temperature;
If not in standby state, long press standby button for 3 seconds until the buzzer rings, the
beverage cooler will enter in standby state, the display screen will turn off.
Except the lighting function, the following operations only be able to carried out under the unlock state.
v
Lighting mode
Press the lighting key until the buzzer rings to turn on/off the internal lamp.
v Switching of the Fahrenheit temperature and Celsius temperature
Press the Temperature-rise key and the Temperature-drop key continuously for 3 seconds to
finish the switch of the Celsius temperature and Fahrenheit temperature; the display area will
show the setting Fahrenheit temperature or Celsius temperature under the existing mode.
Temperature setting
Press the "Temperature-rise key " the temperature will increase 1°C (or 'F). After locking, the
cooler will operate according to the setting value;
Press the "Temperature-drop key *, the temperature will decrease 1°C (or F'). After locking, the
cooler will operate according to the setting value
A Seting range of the Celsius temperature: 1 C~10T; setting
range of the Fahrenhei temperature: 33 ‘T ~50T
v
v
Memory function
The cooler has the power off memory function. After the power is on again, the cooler will work
according to the setting before the power-off.
v Error code:
If the failure happens, the display area will show corresponding error codes as shown
as below table, the user shall contact a specialist for maintenance, so as to make sure
the normal use of beverage cooler.
Error code Description
Fault of temperature sensor
E4 Fault of defrost temperature sensor
Storing too many cans or bottles in the cooler may cause the temperature in the cooler to rise
temporarily.
7

Comfee CRV48S3AST Specifications

General

Brand	Comfee
Model	CRV48S3AST
Category	Refrigerator
Language	English