To Next PageTo Next Page
Need help?Do you have a question about the Comfort Bilt HP22N and is the answer not in the manual?
General| Brand | Comfort Bilt |
|---|---|
| Model | HP22N |
| Category | Stove |
| Language | English |
Explains the meaning of different alert symbols used in the manual.
Lists actions that will void the warranty and risk fire.
Provides warnings about stove usage, installation, power outages, and modifications.
Identifies key components of the pellet stove and their locations.
Lists all items included with the pellet stove package.
Outlines steps for unpacking and preparing the stove for installation.
Provides instructions on mounting the control panel and choosing stove placement.
Specifies requirements for non-combustible flooring and hearth protection.
Details required clearances from the stove to combustible materials.
Specifies minimum clearances for vent termination points on the exterior.
Provides guidelines and cautions for installing the stove's exhaust venting system.
Offers tips on venting, outside air intake, and equivalent vent length calculations.
Illustrates basic horizontal and preferred vertical venting setups.
Details through-roof, Class A chimney, and masonry installation methods.
Provides information on suitable fuel types and proper storage for wood pellets.
Describes initial startup, expected behavior, and basic stove operation.
Details the functions of each button on the stove's control panel.
Explains the meaning of various indicators and information shown on the control panel display.
Lists essential steps to perform before starting the stove's ignition sequence.
Describes the different operating modes: Manual, Temp, and Weekly.
Explains Thstat mode, thermostat connection, and remote control functions.
Guides on starting the stove and assessing the fire quality.
Introduces the menu for adjusting various stove settings.
Details the 'General' and 'Set Weekly' menus for configuring stove parameters.
Explains the 'Set Ash Cleaning Cycle' and 'Diagnosis' menus for stove maintenance and testing.
Covers 'Safe Mode', 'Information', 'Set Blower', and 'Reset' settings.
Emphasizes the importance of regular cleaning for stove performance and longevity.
Describes how to remove side panels to access internal components for cleaning.
Instructs on cleaning the heat exchanger using the built-in scraper.
Details how to clean the burn pot and maintain the ash pan drawer.
Explains cleaning the interior chamber and the stove's front door glass.
Covers cleaning of rear exhaust chambers, including removing cover plates.
Outlines annual maintenance for exhaust venting and the combustion blower.
Points to resources and how to clear error messages.
Addresses power loss and low temperature alarms, their causes, and solutions.
Discusses causes and solutions for high temperature/overheat and failure to ignite alarms.
Addresses lazy flames, smoke, and buildup indicating airflow problems.
Troubleshoots auger feed problems and 'Lost Connect' alarms.
Details errors related to room temperature sensors and overheating.
Lists the stove's BTU output, efficiency, electrical ratings, and glass specifications.
Outlines the warranty coverage, exclusions, and terms for Comfortbilt stoves.
Lists electronic, motor, and fan components available for replacement.
Lists sensor, switch, and miscellaneous replacement parts for the stove.
