8
HOLD DOWN BRACKETS (OPTIONAL)
SKEW ADJUSTMENT (IF NECESSARY)
If the shade does not raise evenly, rst make sure the mounting
brackets are mounted level with each other.
If the shade is level and it still skews, operate the shade to
the full down position. Prepare a strip of masking tape
approximately 5” long. On the side of the shade opposite of
the skewing direction, and as close to the end of the roller as
possible, li the fabric toward the back of the shade using your
ngers and slide the tape with the sticky side facing the roller
up as far as possible. e tape is to be running parallel to the
roller.
Roll the shade up and check for skewing. If the shade is still
skewing, add another strip of tape on top of the rst one. If the
shade is now skewing in the opposite direction, tear o about
1” of tape from the last strip installed. e tape is to be torn
from the end closest to the center of the shade.
Place tape at this end
Optional hold down brackets are mounted with the supplied
screws.
With the shade at its proper drop, place the pin of each hold
down into the hole in each end cap and mark the screw holes.
Make sure the pins are level and aligned.
Raise the shade, then screw the hold down bracket into the
mounting surface.
To Next Page
Loading...