ComfortNET CTK01 - Quick Installation Steps; Installing the Thermostat

INSTALLATION POWER UP SETUP USAGE GUIDE ADVANCED MENUS
INSTALLATIONPOWER UPSETUPUSAGE GUIDEADVANCED MENUS

8
 
29

Qu i C K in S t a l l a t i o n St e P S
 Determine location of thermostat installation.
 Mount thermostat base to wall.
 Connect wires to thermostat base.
 Remove battery tag to provide battery power to the thermostat.
 Attach thermostat to base.
 Turn on power to system.
 Set the time.
 Select thermostat operating options in the Thermostat Options Conguration
Menu.
 Perform thermostat/system operation checkout.
 Program thermostat or accept factory programming.
 Touch Run Schedule.
in S t a l l i n g t h e th e r m o S t a t
 Pull the thermostat body o the thermostat base. Forcing or prying on the
thermostat will cause damage to the unit.
 Place base at installation location and mark mounting hole locations on wall using
base as a template.
 Move base out of the way. Drill mounting holes.
 Attach base securely to wall using two mounting screws. Levelling is for
appearance only and will not aect thermostat operation.
 Connect wires to terminal block on base.
 Push excess wire into wall and plug hole with a re resistant material (such as
berglass insulation) to prevent drafts from aecting thermostat operation.
 Remove battery tag to provide battery power to thermostat.
 Carefully line the thermostat up with the base and snap into place.
In s t a l l a t I o n ad v a n c e d In s t a l l e r co n f I g u r a t I o n Me n u
Se t -u P
Sub-menu Item User Modiable Options Comments
Heat Airow Trim
(HT TRM)
-10% to +10% in 2% Incre-
ments
Trims the electric heating airow
by the selected amount.
St a t u S
Sub-menu Item Indication (for Display Only; not User Modiable)
Mode (MODE) Displays the current air handler operating mode
CFM (CFM) Displays the airow for the current operating mode