ComfortZone RX35/RX50/RX65 Operating Instruction
Preface
Thank you for choosing a ComfortZone heat pump. By reading this manual again,
you will get the most out of your heat pump.
Keep the manual in the immediate vicinity of the heat pump as it is an important
action in case of malfunction or alarm.
ComfortZone's heat pump is designed to maintain a long service life and achieve
low outdoor temperatures. Comfort Zone heat pumps have been commercially
available since 2003 and has given us a long and solid operating experience.
The warm indoor air is sucked from the wet rooms to the ComfortZone heat pump,
where the heat is extracted and returned to the house as water-based heat. Extract
air cooled to -15° C is sent out, new fresh indoor air is taken into the house via wall
valves alternatively via a pre-heating air supply unit. The heat pump senses the
heat demand and works with a computer in a favorable manner so that the right
amount of heat is sent to the house heating system.
The extract air heat pump also warms up hot water to a water tank, from which tap
water is collected.
The effective ventilation gives you a very fresh indoor air. Moisture and contamination
are vented and mould problems disappear.
Your installer sets the outdoor air heat pump for outdoor regulation, outdoor - &
indoor regulation or indoor control only. You can fine tune the indoor temperature
via the menu on the display.
Note:
In case of malfunction, first contact your supplier /
installer for technical advice and action
3
To Next Page
Loading...
