Operation precautions and routine maintenance
1. Waterproof and dustproof, no use of coolant.
2. Emergency stop switch button needs to be reset in time after pressing and then use the machine.
3. Standardized installation of the pressure block, the pressure block can not be pressed in the carving work area, the butterfly nut needs to be retained with the
carving work area at least 10mm distance to avoid collision knife.
4. Reasonable choice of raw materials for carving, the shape of the raw material area needs to be larger than the carving range to ensure normal carving.
5. Regular maintenance of CNC machines, you can add lubricating and anti-rust oil to the optical axis to prevent the optical axis rust.
6. Regularly clean the surface dust of the spindle motor (note that the power is disconnected before cleaning).
7. Regularly reinforce the top tightening screw of the coupling, because the screw may become loose after long time use.
8. If you need to use relay mode, it is recommended that the current of external power supply should be more than 12A.
Q&A
1: The motherboard components are loose or faulty.
2: Corresponding axis drive failure.
3: The corresponding axis stepper motor failure.
4: The corresponding shaft coupling is broken or loose.
5: The corresponding screw rod is broken or the screw nut is faulty.
2120
An axis or three axes do not go or go abnormal
1: The motherboard components are loose or faulty.
2: Z-axis motor wire failure
3: Wrong file path
4: Operation error
Z-axis out of control
1: whether the layout size of the document matches the machine.
2: check whether there is an offset (OFFSET), whether the layout settings are correct.
Engraving machine can not carve at the origin
1: Loose or faulty control card
2: Step near the motor failure
3: Driver failure or current subdivision and software settings are inconsistent
4: Z-axis motor line failure
5: Spindle motor failure
Carving depth is not the same
1: Loose or faulty motherboard
2: Fault on the knife block line
3: Insulating material on the surface of the knife block
4: Static interference
Can not automatically to the knife
To Previous Page
Loading...
Need help?
General
