ComMarker OMNI 1 - Page 16

15
5.Import EZCAD Config and select the folder
6.Select folder “EZCAD for Omni 1”---->“ Plug”, and
choose “markcfg7” and click “next”
7.You can see the following window, UV/YAG and
click “next”
8. Change the name if necessary, and input the
right X and Y Axis Length according to the lens.
Click “next”
9.Click “finish” and it will in the device list
10. The status will change into “Ready” when the
machine is on and connected via USB