Commax CDV-704MF - Page 17

7.
Installation
16
2QFHDFWLYDWHG\RXFDQVHWWKHWLPHUVWDUWHQGWLPH
* Reference
- When detecting motion, the photo is saved for 1 scene and the video-clip is saved
for 10 seconds.
- The LED is flickering during the saving of the video-clip. And, when you touch the screen,
the saving is stopped.
- After saving, the front LED stops blinking, and the motion detection is started within
3 seconds.
- This function can be set / used only for an Interphone (monitor) set to master. (ID 1)
- In the night or dark place, the LED of door camera is always on while this function
is working.
0RWLRQGHWHFWLRQ: Can be used only with ID1 (MASTER)
7RVHWPRWLRQGHWHFWLRQRIWKHSUHYLRXVO\VHWFDPHUD
)XQFWLRQVRIHDFKPHQXDUHDVIROORZLQJ

0RWLRQGHWHFWLRQ7RVHWenable / disable function.
6HOHFWLRQRI&DPHUD7RVHOHFWFDPHUDIRUPRQLWRULQJ6HOHFWIURP'RRU&&79
6DYLQJIRUPDW7RVelect storage method.6HOHFWEHWZHHQ3KRWR9LGHR
6HQVLQJRIVHQVLWLYLW\7RVHWVHQVLWLYLW\6HOHFWDPRQJ+LJK0LGGOH/RZ
0RWLRQWLPHU7RVHWXSWKHWLPHUIXQFWLRQDFWLYDWLRQ0RWLRQGHWHFWLRQDFWLYDWLRQWLPH  
- LCD is on for motion detection : During video recording, it shows video on LCD. (for 10 seconds)
3) Always monitor : Can be used only in ID1 (MASTER)
-
-
-
Always-on monitoring and video saving can be possible. (When the call is receiving, the operation will
be terminated automatically)
DOOR1 -> DOOR2 -> CCTV1 -> CCTV2 -> DOOR1… Operated in order.
If there is an SD card, the movie will be saved at the same time. Without SD card, the photo is saved.
① 10 seconds per camera : Video saving and monitoring changes every 10 seconds.
② 30 seconds per camera : Video saving and monitoring changes every 30 seconds.
③ 60 seconds per camera : Video saving and monitoring changes every 60 seconds.