12
13
Note On Use and Installation
Do Not Aim The Camera At The Sun
Do not aim the camera at the sun or point it at the sun even if
you are not shooting.
Do Not Shoot Intense Light
Framing intense light such as a spotlight may cause bloom or
smear. A vertical stripe may appear on the screen. However, this
is not a malfunction.
Treat The Camera With Care
Do not drop the camera or subject it strong shock of vibration.
Otherwise, the camera may malfunction.
Never Touch Internal Parts
Do not touch the internal parts of the camera other than that
parts specified. Otherwise, the camera may malfunction.
Plug off when you do not intend to use the camara for a long
time.
Do Not Slash Water On The Camera
Install the camera where the camera can be kept dry. If the
camera gets wet, turn off the power and contact you dealer.
Install The Camera Where No Video Noise Appears
If cables are wired near electric lightning wires or a TV set, noise
may appear in images. In this event, relocate cables or reinstall
equipment.
Check The Ambient Temperature And Humidity
Avoid using the camera where the temperature is hotter or colder
than specified. Otherwise, the quality of images may deteriorate
or internal parts may be affected. Special care is required to use
the camera at high temperature and humidity.
Should You Notice Any Trouble
If any trouble occurs while you are using the camera, turn off the
power and contact your dealer. If you continue to use the camera
when there is someting wrong with it, the trouble may much
worse and an unpredictable accident may occur.
Before You Call
Try the troubleshooting guide on the following pages. If you still can’t solve your problem, try one more thing before you call.
1. Attetion to your unit is operating to the DC receptacle.
2. Do not disassembly before for qualified personnel.
3. Make sure that connector the unit back in and try your procedure again as block diagram.
Getting Help
If you still can’t correct an operating problem, contact your dealer. If your dealer is unable to solve your problem, contaact Commax
Customer Service, Please don’t open the cabinet and attempt to repair the unit, as this will void your warranty.
Unplug the unit and refer servicing to qualified service personnel when:
· The power supply or plug damaged.
·The unit has been exposed to rain or water.
·A solid object or liquid has fallen into the unit.
·The unit exhibits a distinct change in performance or will not operate normally.
Troubleshooting Guide
To Next Page
Loading...
Need help?
General
