Commodore 16 - Page 13

SETTING UP
YOUR COMPUTER
The On/Off Switch
• There is a red power light located above the key
board on the right. This lights to show you that the
power is ON.
• Make sure your Commodore 16 is turned OFF when
you install or remove cartridges or any peripheral
device, such as a printer or disk drive.
The Joystick Sockets
• The joystick controllers plug in here.
• Your Commodore 16 uses specially designed joy
sticks for games and other uses/available from your
Commodore dealer.
The Reset Button
• Press the reset button when you want to "start
over", to get a cleared screen and memory as if you
just turned your computer off then on again.
The Power Socket
• The round end of the cord from your power supply
plugs in here.