Commodore 16 - Page 49

USING SOFTWARE
6 Your software is now ready to use. Type
RUN and press the ^gRli key to start
the program.
• You have to supply either program name for a *) in
the DLOAD command. Follow the instructions that
came with the software. .,.
• If the red light on the disk drive blinks after the
DLOAD is finished, something went wrong. Type:
?DS$ (and press J*
to find out what went wrong.
Examples of DLOAD commands:
DLOAD "*" LOADs the first program on the
disk.
DLOAD "FILES" LOADs a disk program called
FILES.
35