Commodore Plus 4 - Page 47

-
SEARCHING FOR PROGRAM NAME
LOADING
READY
~
Headering
A
Diskette
STEP 6 Your software is ready to use. Now type RUN and press the
RETURN key to start the program.
If the red light on the disk drive blinks after the DLOAD is finished,
something went wrong. Type:
?DS$ (and hit RETURN )
to find out what went wrong.
Examples of DLOAD commands:
~
LOADs the 1st
program on the disk.
LOADs a disk
program called
MYFILE.
LOADs the first
program on the disk
that begins with the
letters SET.
LOADs the directory,
a listing of all the
programs on the disk
in the drive.
Headering prepares a new BLANK disk for use. Any blank disk must
be formatted before it may be used, by using the HEADER command.
IMPORTANT; DO NOT HEADER A DISK THAT HAS ANYTHING
ON IT UNLESS YOU WANT TO ERASE THE ENTIRE DISK.
HEADERING ERASES EVERYTHING ALREADY ON A DISK.
DLOAD11*"
DLOAD "MYFILE"
DLOAD "SET*"
DLOAD "$"
. I