To Next PageTo Next Page
Need help?Do you have a question about the CommScope NOVUX SRC100 and is the answer not in the manual?
General| Dimensions | 20 mm x 134 mm x 140 mm | 0.8 in x 5.3 in x 5.5 in |
|---|---|
| Weight | 0.25 kg | 0.55 lb |
| Return Loss | 16 dB |
| Humidity | 5%-95%, non-condensing |
| Operating Temperature | -40°C to +60°C |
Displays the physical measurements of the SRC100 closure and its components, providing key dimensions in millimeters and inches.
Specifies the acceptable diameter range for drop cables, including flat cable dimensions, for proper installation in the SRC100 closure.
Details the compatibility of different ITU-T fiber types (G.652D, G.657) with the SRC100 closure configurations for splicing and patching.
Provides a step-by-step guide on how to open the SRC100 closure, involving the manipulation of latches and levers using a screwdriver.
Explains the procedure for installing the Octopus™ gel blocks into the cover and base of the SRC100 closure, ensuring secure placement.
Refers to a separate document for instructions on using jacket strain relief (Mclip) for cable retention in the SRC100 closure.
Details the steps for preparing the drop cable, including jacket removal, tube marking, and fiber routing, with a note for 48 splice configurations.
Shows the specific arrangement of fibers and splice trays for a 12-splice configuration within the SRC100 closure.
Depicts the internal layout for managing and splicing fibers in a 24-splice configuration within the SRC100 closure.
Presents the fiber splicing layout for the 48-splice capacity of the SRC100 closure, showing fiber management.
Explains how to attach the SRC100 closure to walls or poles using screws, noting that mounting hardware is not included.
Illustrates the procedure for mounting the SRC100 closure onto poles using straps, with a note about hardware not being included.
Describes how to use a security wire to lock the closure, securing it through top and bottom holes for tamper resistance.
