6. Error rectification
[Indication] / Problem Possible cause Remedy
24
CONTINUOUS OPERATION operating mode
selected
(4)
Select AUTOMATIC OPERATION
operating mode
Unit runs continuously in off-
load without independently
switching to readiness (standby)
Very brief pressure requirements during the
run-on time
No compressed air
requirements within the
switching points set
(4)
Pressure changeover by timer or
external contact active
(5)
(1) Unit-specific setting: see 5.4 [ LIMIT VALUES ] menu
(2) Individual setting: see section 4 [MAINTENANCE SCHED.] menu
(3) Individual setting: see section 5.5 [OPTIONAL IN-/OUTPUTS] menu
(4) Individual setting: see section 5.1 [ CONTROL MENU ] menu
(5) Individual setting: see section 5.3 [ TIMER CONTROL ] menu
To Next Page
Loading...
