Compak F8 OD - 8.2. Adjust the lower portafilter support in models with Dynamometric press system DYN; 8.3. Grind point adjustment

10
ORIGINAL INSTRUCTIONS | Ref. quality process 002/03 | v. 21/07/2015 | K06315
8.2.Adjustthelowerportaltersupportinmodelswith
DynamometricpresssystemDYN
1. Remove screw caps (Fig. 2)usingaatheadedscrewdriver.
2. Adjust the mobile fork as described in section 8.1.
3. Replace and tighten the screw caps (Fig. 2).
8.3.Grindpointadjustment
Placeportalterinupperportalterholder( )andpushtherellbutton( ) until
ground coffee begins to dispense from exit chute.
To adjust the grind point, simply turn the grind adjustment knob. A clockwise
adjustmentwillrenderanergrindandacounterclockwiseadjustmentwillrender
a more coarse grind.
CAUTION:Changing grind settings must be done when the grinder is on and burrs are in
motion. Not doing this suposes that the burrs will gunk up and cleaning will be required.