the display are routed in their plastic "grooves". You will need to put them back there when
you put the keyboard back in.
Do not be tempted to play with the grey latches for the drive/battery bays. These too
are spring loaded and not well secured once the keyboard is out.
15. If you need to service the fan, you can now do so. The fan is a black foam-encased
assembly mounted next to the processor board. It lifts up and plugs into the motherboard
underneath the processor card.
16. To reset the power-on/standby/BIOS password, locate the small jumper at the upper
left of the processor heatsink. This jumper may be toggled to remove the password.
Change the position from pins 1-2 to 2-3 and then set it back. With care the computer may
be powered in this state to verify that password deletion was successful. You will have
reconnect the internal keyboard or use an external one for this task.
To Next Page
Loading...
