17. At this point the entirety of the LTE motherboard, processor card, memory slots and
charging circuit will be visible. (Some of this is hidden under the metal shielding, which I
suggest you remove and discard...) Each of these assemblies may be removed, but for the
moment I do not have directions here on doing this. If you should attempt this (and I have)
I recommend use of common sense, extreme caution and the creation of notes as to how
things go together. Also be sure you keep track off all the screws and where they go.
Reassembly
18. Place the keyboard back into its location. Press down on the snaps you pried up earlier
to seat the keyboard into place.
19. Reconnect the pointing device, microphone and keyboard cables. Do not yet connect
the ground wires. Make sure all the connections are properly and evenly seated. Reroute
the cables into the guides they came from when you pulled the keyboard out.
20. Reconnect the ground wires. To do this easily, place the screws into the loop at the
end of the two ground wires. Use the wire to position the screw. Set the wire into the
molded guide in the keyboard plastic. Make sure the wire stays in place as you tighten the
screws. Routing these wires correctly is important!
To Next Page
Loading...
Need help?
General
