R
EPLACING AN
E
XPANSION
C
ARD
9
V. Replacing the Expansion Card
Note: Save all the packing materials received with your replacement card.
You will need them to return the defective part.
1. Align the expansion card with the PCI slot 1 on the
system board and with the expansion card rear
connector(s) slot on the chassis (see Figure 5-1).
Important: The expansion card rear connector must be properly inserted
into the rear chassis slot to ensure the card is properly seated into the PCI
slot on the system board.
2. Replace the screw 2 to secure the expansion card to the
chassis (see Figure 5-1).
Figure 5-1
Insert the new expansion card
into the same connector from
which the defective card was
removed.
Ensure the card is properly
positioned into the rear
connector slots on the chassis.
To Next Page
Loading...
