e. Display assembly (see Display assembly on page 76)
f. Top cover (see
Top cover on page 83)
Remove the rear cover:
1. Turn the computer upside down, with the rear panel toward you.
2. Remove the three Torx8 T8M2.5×9.0 screws that secure the rear cover to the base enclosure.
3. Turn the computer right side up, with the front toward you.
4. Remove the three Phillips PM2.5×3.0 broad-head screws (1) and the two Phillips PM2.5×5.0
screws (2) that secure the rear cover to the base enclosure.
5. Lift the rear edge of the rear cover (1) until it disengages from the base enclosure.
96 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
