3. Turn the computer right-side up, with the front toward you.
4. Disconnect the following cables from the system board:
●
Bluetooth module cable (1)
●
TouchPad cable (2)
●
Fingerprint reader board cable (if equipped) (3)
●
USB board cable (4) and release from top cover clips (5)
●
Num lock light cable (6)
5. Remove the two Phillips PM2.5×7.0 screws (1) that secure the top cover to the computer.
6. Lift up the rear edge of the top cover until it releases from the base (2).
70 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
