EasyManua.ls Logo

Compaq SLT/286 - Page 18

Compaq SLT/286
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Detection Error problem; added 2. Check the
or removed the coprocessor
coprocessor installation.
3. Replace the
coprocessor.
------------------------------------------------------------------------------
1125 - Internal Serial 2 Short Defective Replace the
Port Failure internal system board.
serial port
------------------------------------------------------------------------------
1150 - Comm Port 2 Short Added or Run SETUP.
Configuration Error removed modem,
or second
serial
interface
board
------------------------------------------------------------------------------
1780 - Disk 0 None Fixed disk 1. Run DIAGNOSTICS.
Failure drive/format 2. Replace the
error drive.
------------------------------------------------------------------------------
1781 - Disk 1 None Fixed disk 1. Run DIAGNOSTICS.
Failure drive/format 2. Replace the
error drive.
------------------------------------------------------------------------------
Probable Recommended
Message Beeps Cause Action
------------------------------------------------------------------------------
1782 - Disk None Fixed disk 1. Run DIAGNOSTICS.
Controller Failure drive 2. Replace the
controller drive.
error
------------------------------------------------------------------------------
1790 - Disk 0 None Fixed disk 1. Run DIAGNOSTICS.
Error drive error 2. Replace the
drive.
------------------------------------------------------------------------------
XX000Y ZZ Parity None Parity RAM Run DIAGNOSTICS.
Check 2 failure
------------------------------------------------------------------------------
Audible * 1 Short Power on None.
successful
------------------------------------------------------------------------------
Audible * 2 Short Power on None.
successful
------------------------------------------------------------------------------
(RESUME = "F1" KEY) None As indicated Press F1 key.
to continue
------------------------------------------------------------------------------
* Beeps can be disabled by the user during the SETUP program.
==============================================================================

Related product manuals