Compaq SLT 386s/20

610 - 06 Fatal error while reading
610 - 07 Fatal error while writing
610 - 08 Failed compare of write/read
buffers
610 - 09 Failed to format a track
------------------------------------------------------------------------------
Error
Code Description Recommended Action
------------------------------------------------------------------------------
610 - 10 Failed sector wrap test The following steps apply to error
codes 600 - xx through 610 - xx:
610 - 20 Failed to get drive type
1. Replace the diskette and retest.
610 - 21 Failed to get change 2. Check and/or replace the power
line status and signal cables and retest.
3. Replace the diskette drive and
610 - 22 Failed to clear change retest.
line status 4. Replace the system board and
retest.
610 - 23 Failed to set drive type
in ID media
610 - 24 Failed to read diskette
media
610 - 25 Failed to verify diskette
media
610 - 26 Failed to read media in
speed test
610 - 27 Failed speed limits
610 - 28 Failed write protect test
------------------------------------------------------------------------------
697 - 00 Diskette type error The following steps apply
to error codes 697 - xx through
698 - 00 Diskette drive speed not 698 - xx:
within limits
1. Replace the diskette and
retest.
2. Check and/or replace the
diskette signal and power cable
and retest.
3. Replace the diskette drive and
retest.
4. Replace the system board and
retest.
------------------------------------------------------------------------------
699 - 00 Diskette drive/media ID 1. Replace the media.
error, rerun SETUP 2. Run SETUP.
==============================================================================